SOLICITATION NOTICE
95 -- BPA 7FLIS-A6-7240E-04 UTILITY PAIL, (STEEL)
- Notice Date
- 6/28/2004
- Notice Type
- Solicitation Notice
- NAICS
- 332612
— Spring (Light Gauge) Manufacturing
- Contracting Office
- General Services Administration, Federal Supply Service (FSS), Southwest Supply Center (7FL), 819 Taylor Street RM 6A06, Fort Worth, TX, 76102
- ZIP Code
- 76102
- Solicitation Number
- 7FLIS-A6-7240E-04
- Response Due
- 7/13/2004
- Archive Date
- 7/28/2004
- Point of Contact
- Barbara Goolsby, General Supply Specialist, Phone 817-978-7204, Fax 817-978-0002, - Barbara Goolsby, General Supply Specialist, Phone 817-978-7204, Fax 817-978-0002,
- E-Mail Address
-
barbara.goolsby@gsa.gov, barbara.goolsby@gsa.gov
- Description
- This Solicitation is to establish a BPA (blanket purchase agreement) for a period of one year from the date of award for the nsn listed below. See attached Solicitation for more information. The destinations and quantities will be determined by on demand requisitions from various agencies. The quantities listed are not correct, as we have no way of knowing the quantities that will be requested for a BPA period. 1. NSN: 7240-00-754-1298 PAIL, UTILITY (STEEL): Lightweight utility pail is intended for general purpose use and shall have the following characteristics; Capacity - 10 quarts Wire bail ? Galvanized Without pouring lip Watertight The bottom and top rims of the pail shall be reinforced with a steel band strip or be integral with a rolled edge or by any other commercial manufacturing method that will provide rigidity. The body of the pail shall be tapered to allow nesting. The pail body shall be galvanized sheet steel or uncoated sheet steel 0.0097-inch minimum thickness. Components fabricated from uncoated sheet steel shall be hot-dip galvanized on both sides in accordance with ASTM A123 or ASTM A653. Copies of ASTM standards are available from the American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959. Unit of issue is dozen (DZ) Product Conformance. The products provided shall meet the salient characteristics of this purchase description, conform to the producer?s own drawings, specifications, standards, and quality assurance practices and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance. PREPARATION FOR DELIVERY: The utility pails shall be packaged and packed to afford adequate protection against physical damage during shipment from the supplier to the first receiving activity. The pack shall comply with the rules and regulations applicable to the mode of transportation. The package shall be the same as that normally provided by the supplier. In the event a pallet or skid is used for shipping, the following notice shall apply: NOTICE: Due to the spread of oak wilt disease, all lumber used inside or outside a shipment must be BARK FREE. NOTICE OF SPECIAL REQUIREMENTS FOR SHIPMENT TO EUROPEAN UNION COUNTRIES: Per Clause D-FSS-468, non-manufactured wood pallets and other non-manufactured wood package material used in shipments destined for ultimate delivery to or through a European Union (EU) country shall comply with the Emergency Measures (2001/219/EC) adopted by the Commission of the European Communities (CEC). Additionally, shipments delivered to DoD distribution facilities or freight consolidation points for eventual delivery to or through EU countries shall comply with DLA PROCLTR 02-17. MARKING: Shipments to GSA and other civilian agencies shall be marked in accordance with FED-STD-123. Shipments to the Department of Defense (DOD) shall be marked in accordance with MIL-STD-129.
- Record
- SN00611492-W 20040630/040628212443 (fbodaily.com)
- Source
-
FedBizOpps.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |