SOURCES SOUGHT
34 -- Fabrication and Installation of hubbing presses capable of hubbing coinage dies.
- Notice Date
- 11/10/2010
- Notice Type
- Sources Sought
- NAICS
- 333513
— Machine Tool (Metal Forming Types) Manufacturing
- Contracting Office
- Department of the Treasury, United States Mint (USM), Manufacturing Procurement Branch, 801 Ninth Street, NW, Washington, District of Columbia, 20220, United States
- ZIP Code
- 20220
- Solicitation Number
- USM-HQ-11-0010
- Point of Contact
- Lourdes L. Irizarry, Phone: 2023547598
- E-Mail Address
-
lirizarry@usmint.treas.gov
(lirizarry@usmint.treas.gov)
- Small Business Set-Aside
- N/A
- Description
- THIS IS NOT A SOLICITATION, IT IS A SOURCES SOUGHT NOTICE The United States Mint, Manufacturing Department, Washington, DC is seeking qualified vendors capable of fabricating and installing a hydraulic hubbing press capable of hubbing coinage dies at the United States Mint, Philadelphia. The vendor shall have the capability to design, manufacture and service new hubbing presses with the following: A. Capacity: 2500, 1250 and 630 metric tons. B. Range: Desired die sizes is 15 mm - 150 mm. C. Mechanical Requirements: 1. PLC control 2. Table ejector. 3. Two hand push button operation. 4. Single stroke hubbing using automatic cycle. 5. Multiple hubbing forces within one hubbing stroke. 6. Adjustable ram guidance. 7. Automatic safety shield at front of press. 8. Adjustable hubbing speed. 9. Adjustable dwell time. 10. All documentation, signage and control panels in English language. 11. Service technicians with English language capability. 12. 460 volt, 3 phase, 690 Hz power. RESPONSES to this SOURCES SOUGHT NOTICE shall be submitted electronically to Lourdes Irizarry at LIrizarry@usmint.treas.gov no later than November 29, 2010 2:30 PM EST. Your response must include at the minimum the following information: A. Technical Information Requirements: 1. Adjustable pressing capacity. 2. Working pressure. 3. Maximum daylight (tool space), piston down. 4. Ram stroke. 5. Active clamping surface, upper and lower press platen. 6. Table height above floor. 7. Closing, opening and pressing speeds. 8. Table ejector force, size (diam.) and stroke. 9. Driving power in kw. 10. Air Requirement @ pressure requirement. 11. Oil requirement. 12. Layout drawing. 13. Floor load. 14. Floor space requirements. 15. Press height 16. Press weight: with and without oil. B. Business Information: 1. Past Performance history in the field of hubbing presses. 2. List of company's operating hubbing equipment inside the United States. Operating hubbing equipment outside of the United States may also be listed (identified)
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/TREAS/USM/CirPr/USM-HQ-11-0010/listing.html)
- Place of Performance
- Address: United States Mint, 151 N Independence Mall E, Philadelphia, Pennsylvania, 19106-1886, United States
- Zip Code: 19106-1886
- Zip Code: 19106-1886
- Record
- SN02325822-W 20101112/101110234232-e0a88c32e34ff57f805a9e393de1dda3 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |