SOURCES SOUGHT
59 -- Network Analyzer & Support Equipment
- Notice Date
- 6/26/2012
- Notice Type
- Sources Sought
- NAICS
- 334515
— Instrument Manufacturing for Measuring and Testing Electricity and Electrical Signals
- Contracting Office
- Department of the Air Force, Air Force Materiel Command, AFNWC/PKO - Kirtland (Operational Contracting Division), AFNWC/PKO Operational Contracting Division, 2000 Wyoming Blvd SE, Bldg 20604, Room B-9, Kirtland AFB, New Mexico, 87117-5606, United States
- ZIP Code
- 87117-5606
- Solicitation Number
- F2KBAB2076A001
- Archive Date
- 7/3/2012
- Point of Contact
- Ernest J Hernandez, Phone: 5058465713
- E-Mail Address
-
ernest.hernandez@kirtland.af.mil
(ernest.hernandez@kirtland.af.mil)
- Small Business Set-Aside
- N/A
- Description
- The Air Force requires a Vector Network Analyzer/ Impedance Analyzer (VNA/ZA) optimized for low frequency circuit measurements. Requirements are based on Agilent E5061B with options 3L5/020/ 005/720/1E5 or equal is acceptable. Basic requirements: S-parameter test port measurements: 5 Hz to 3 GHz Port 1 Reflection, Port 2 Reflection, Port 1-2 Series-thru, Port 1-2 Shunt-thru System dynamic range: 100 kHz to 1 MHz, 3 kHz IF bandwidth 90 dB 1 MHz to 3 GHz, 10 Hz IF bandwidth 120 dB Uncorrected directivity 25 dB (300k to 3 GHz) Uncorrected source match 35 dB (300k to 3 GHz) Gain phase test port measurements: 5 Hz to 30 MHz 1 Mohm input impedance Gain-phase Series-thru, Gain-phase Shunt-thru Impedance analysis (ZA) firmware for comprehensive component and characterization RF source power level: -45 to + 10 dBm (into 50 Ω) Sweep types: Linear, Logarithmic frequency sweep, Segment sweep, Power sweep Number of point: 2 to 1601 Calibration: Impedance calibration (open/short/load and optional low-loss capacitor). Response thru calibration, Full 1-port calibration, Full 2-port calibration, Port extensions. Fixture compensation: Fixture selection (port extension for 7 mm fixtures), open/short/load Required accessories and calibration kits: 7 mm terminal adapter kit for E5061B: such as 16201A-001 or equal 7 mm calibration kit (open/short/load + low-loss capacitor): such as 16195B or equal 7 mm test fixture for SMD & leaded component: such as 16092A or equal 4-terminal pair test fixture for leaded components: such as 16047E or equal 4-terminal pair test fixture for SMD components: such as 16034E or equal 4-terminal pair test fixture for SMD components: such as 16034G or equal
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/USAF/AFMC/377CONSKOC/F2KBAB2076A001/listing.html)
- Record
- SN02786015-W 20120628/120626234652-f5235bae98f5ffb787d42b18e19fcad4 (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |