DOCUMENT
65 -- Surgical Case Carts - Attachment
- Notice Date
- 9/11/2018
- Notice Type
- Attachment
- NAICS
- 339113
— Surgical Appliance and Supplies Manufacturing
- Contracting Office
- Department of Veteran Affairs;Network Contracting Office 10;5500 Armstrong Rd.;Battle Creek MI 49037
- ZIP Code
- 49037
- Solicitation Number
- 36C25018Q9865
- Response Due
- 9/14/2018
- Archive Date
- 11/13/2018
- Point of Contact
- Jeffrey P. Rozema
- E-Mail Address
-
y.rozema@va.gov<br
- Small Business Set-Aside
- Service-Disabled Veteran-Owned Small Business
- Description
- The purpose of this amendment is to issue the following changes/clarifications to the surgical case cart specifications due to vendor questions and comments. Updates are listed in bold text. As a result of these changes, the closing date for this solicitation has been moved from Wednesday, September 12, 2018 to Friday, September 14, 2018 at 4:00 PM EST. Sterile Surgical Case Cart Specifications: Cart Type 304 Stainless Steel (SS) with #6 (or higher) mill finish on all cart surfaces. (20) Carts total: (10) double door enclosed surgical case carts with one roll out solid shelf each. External dimensions with 46 x 28.5 x 39 (L x W x H) (10) double door enclosed surgical case carts with two roll out solid shelves each. External dimensions with 46 x 28.5 x 56 (L x W x H) Cart length can be up to 3 longer than stated dimensions on both carts. Cart width can be up to 1 wider than stated dimensions on both carts. Cart height can be up to 3 taller than stated dimensions on both carts. Dimensions include castors and bumpers. Fully welded, unibody design case cart. No mechanical fasteners for attaching hinges, bumpers or handles on to cart. Each cart will have three parts top cap, body and bottom chassis. Top cap and body will be constructed with 18-gauge SS (or thicker). Chassis will be 14-gauge SS (or thicker). Chassis will be welded to the body at 90o. Top cap will be welded to the body at 90o. SS structural support bar will run the length of the top cap, in its middle, as reinforcement to ward off bowing. Rubber gasket (or equivalent material) will be placed between top cap and support bar to reduce vibration and noise. Bumper wrapped around the whole cart. Made from 14-gauge SS attached to the bottom chassis. Bumper extends away from cart by at least two inches to allow for water drainage and drying. There will be a maximum of three inches spacing between bumper brackets. Rubber bumper insert, easily removable for replacement, is one single continuous section and ozone resistant. Exterior push handles, ergonomically positioned on both ends of cart, utilizing one-inch diameter cylindrical stainless steel for hand comfort. Must be fully welded to cart. 8.5 inch x 11 inch card holder welded on the outside of one of the doors. Exterior security latch. Shelves Roll out, solid shelves only. No wired shelves Stainless steel shelves made from 18-gauge SS or thicker. Latch(es) to hold shelves in closed position for automated cart washing. Doors Double-sided made from 18-gauge SS. Doors filled with sound deadening foam (or equivalent material) to reduce noise, add strength, improve structural integrity, and ensure doors remain in alignment. Completely sealed doors to prevent bacterial and/or water entrapment. No weep holes in doors. This means the doors themselves must be sealed in such a way that no water can get inside the doors; it does not mean that special seals are required to prevent water from getting past the doors and into the cart. Doors open and lock at 270o so cart can run through cart washer. Casters (4) 6 diameter premium plate-mounted, swivel casters. Smaller castors not acceptable. Casters made with sealed, stainless steel, maintenance free, self-greasing bearings. Minimum load rating capacity: 300 lbs/caster Temperature rated for 0oF to 180oF
- Web Link
-
FBO.gov Permalink
(https://www.fbo.gov/spg/VA/BCVAMC515/BCVAMC515/36C25018Q9865/listing.html)
- Document(s)
- Attachment
- File Name: 36C25018Q9865 36C25018Q9865_1.docx (https://www.vendorportal.ecms.va.gov/FBODocumentServer/DocumentServer.aspx?DocumentId=4586872&FileName=36C25018Q9865-001.docx)
- Link: https://www.vendorportal.ecms.va.gov/FBODocumentServer/DocumentServer.aspx?DocumentId=4586872&FileName=36C25018Q9865-001.docx
- Note: If links are broken, refer to Point of Contact above or contact the FBO Help Desk at 877-472-3779.
- File Name: 36C25018Q9865 36C25018Q9865_1.docx (https://www.vendorportal.ecms.va.gov/FBODocumentServer/DocumentServer.aspx?DocumentId=4586872&FileName=36C25018Q9865-001.docx)
- Record
- SN05083372-W 20180913/180911231101-44ada0b7b5657ec8cd4817aee4c1394a (fbodaily.com)
- Source
-
FedBizOpps Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's FBO Daily Index Page |