Loren Data's SAM Daily™

SAMDAILY.US - ISSUE OF DECEMBER 18, 2020 SAM #6959
SPECIAL NOTICE

99 -- Integrated High Definition Range Camera Systems

Notice Date

12/16/2020 10:49:28 AM
 

Notice Type

Special Notice
 

NAICS

333316 — Photographic and Photocopying Equipment Manufacturing
 

Contracting Office

W6QK ACC-APG DIR ABER PROV GRD MD 21005-3013 USA
 

ZIP Code

21005-3013
 

Response Due

12/21/2020 7:00:00 AM
 

Archive Date

01/05/2021
 

Point of Contact

Mr. Kashif Reese
 

E-Mail Address

kashif.i.reese.civ@mail.mil
(kashif.i.reese.civ@mail.mil)
 

Description

camera system must have the following characteristics: 1. 1/2.8 type Exmor CMOS sensor, with minimum of 2.13 megapixels, HD-SDI output 2. Minimum of 30X optical zoom, with f=4.3 mm (wide) to 129 mm (tele), and 12X digital zoom 3. Lens aperture of F1.6 wide to F4.7 tele 4. Horizontal viewing angle in 1080p mode, 59.5 to 2.1 degrees 5. Pan and Tilt Positioner: a. Payload rated load torque: 50 lbf-ft, payload capacity: up to 75 pounds b. Maximum current draw of 4.5 amp peak, 3 amp continuous, 650 mAmp standby c. 65 Watt heater power d. Operating voltage range of 24VDC, 24-28 VDC e. Minimum azimuth travel of 435 degrees, with speed from 0.005 to 50 degrees per second f. �Minimum elevation travel of 180 degree, +/- 90 degree from horizon, with speed from 0.005 to 12 degrees per second g. Minimum incremental movement of 0.01 degrees h. Both mechanical and software adjustable limit stops i.� Position feedback with 9000 line encoder resolution of 0.01 degrees with repeatability of 0.05 degrees.� 1.8 degree stepper motor. j.� IP67 environmental rating, operating temperature without heater (-15C to 55C) with heater -30C to 55C k. Powder coated finish, cast aluminum housing with stainless steel hardware l.� Integral web server.� Moog PTCR-1000, Pelco-D protocol m. Velocity commands of 10-bit, linear response n.� Minimum monitoring of power on and run time, voltage, current, with real-time clock o.� Ability to interface with payload with Serial RS232, RS422, RS485 configurable communication, 4 ports; 2 TTL, 1 IP p.� Minimum (1) 53 conductor connector for positioner, and (2) 53 conductor connector for payload q.� Payload mounting surface size of 10 inches by 5 inches for replacement/additional cameras r.� Hardened steel worm drive gears s. Controllable with a Unicom joystick 6. �Power supply unit of 85-260 VAC input, 24VDC 10.2 amp output 7. �Base STD 53S with flying leads cable 8.� Unicom LT ruggedized controller joystick 9.� 8 FT input AC outdoor power cable 10. 1 day operating training and phone technical support����� 1.� Quantity (24), 2-JA-V0129H-000-MWS, Custom camera system with MPT-50 positioner 2.� Quantity (24), 7-08964, PSU power supplies, IN: 85-260 VAC, OUT 24VDC 10.2A 3.� Quantity (24), CC56545-25, Cable, Base STD 53S w/flying leads 4.� Quantity (5), CLT-1000R, Ruggedized Unicom joystick controller 5.� Quantity (24), 6-19235-8, Outdoor 8FT cable input AC
 

Web Link

SAM.gov Permalink
(https://beta.sam.gov/opp/c9f3319d4c3e44da906c79e1ba181aeb/view)
 

Place of Performance

Address: Aberdeen Proving Ground, MD 21005, USA

Zip Code: 21005

Country: USA
 

Record

SN05875219-F 20201218/201216230145 (samdaily.us)
 

Source

SAM.gov Link to This Notice
(may not be valid after Archive Date)

---

| FSG Index  |  This Issue's Index  |  Today's SAM Daily Index Page |