SPECIAL NOTICE
R -- Preventative Maintenance and Service of Laboratory and Controlled Environment Equipment
- Notice Date
- 9/13/2022 7:38:46 AM
- Notice Type
- Special Notice
- NAICS
- 561210
— Facilities Support Services
- Contracting Office
- FOREST SERVICE US
- ZIP Code
- 00000
- Solicitation Number
- 12444822P0153
- Response Due
- 9/20/2022 5:00:00 AM
- Point of Contact
- Gayle Geiger, Phone: 317-514-1365
- E-Mail Address
-
gayle.geiger@usda.gov
(gayle.geiger@usda.gov)
- Description
- TEST AND INSPECT: Job labor, travel labor and travel and living expenses required to visually INSPECT and TEST equipment to determine its operating condition and efficiency. �TESTING for excessive vibration; motor winding resistance; refrigerant charge; fan RPM; refrigerant oil(acid); water condition; flue gas analysis; safety controls; combustion and draft; crankcase heaters; controlsystem(s), etc. �INSPECTING for worn, failed or doubtful parts; mountings; drive couplings; oil level; rotation; soot; flamecomposition and shape; pilot and igniter; steam, water, oil and/or refrigerant leaks, etc. PREVENTIVE MAINTENANCE: Job labor, travel labor and travel and living expenses required to clean, align, calibrate, tighten, adjust, and lubricate. These activities are intended to extend equipment life and assure proper operating condition and efficiency. �CLEANING condenser coil surfaces is not included; fan impellers and blades; electrical contacts; burner orifices; passages and nozzles; pilot and igniter; cooling tower baffles, basin, sump and float; chiller, condenser and boiler tubes, etc. �CLEANING evaporator coil surface is not included. �ALIGNING belt drives; drive couplings; air fins, etc. �CALIBRATING safety controls; temperature and pressure controls, etc. �TIGHTENING electrical connections; mounting bolts; pipe clamps; refrigerant piping fittings; dampersections, etc. �ADJUSTING belt tension; refrigerant charge; super heat; fan RPM; water chemical feed and feed rate; burnerfuel/air ratios; gas pressure; set point; set point of controls and limits; compressor cylinder unloaders; damperclose-off; sump floats, etc. �LUBRICATING motors; fan and damper bearings; valve stems; damper linkage; fan vane linkages, etc.
- Web Link
-
SAM.gov Permalink
(https://sam.gov/opp/5c8131b29423465ca5f023e27ff1582f/view)
- Place of Performance
- Address: Morgantown, WV 26505, USA
- Zip Code: 26505
- Country: USA
- Zip Code: 26505
- Record
- SN06462762-F 20220915/220913230127 (samdaily.us)
- Source
-
SAM.gov Link to This Notice
(may not be valid after Archive Date)
| FSG Index | This Issue's Index | Today's SAM Daily Index Page |