Department of the Army, Headquarters, Military Traffic Management Office, ATTN: MTTM-T Room 629, 5611 Columbia Pike, Falls Church, VA 22041-5050

81 -- 36 X 20' ISO DRY CARGOWORTHY CONTAINERS SOL DAMT01-98-Q-9913 DUE 050698 POC Sarah C. Wiley (703) 681-9770 WEB: wileys@baileys-emh5.army.mil, wileys@baileys-emh5.army.mil. E-MAIL: wileys@baileys-emh5.army.mil, wileys@baileys-emh5.army.mil. THIS REQUIREMENT IS SET ASIDE FOR SMALL BUSINESS PARTICIPATION ONLY. PLEASE INDICATE SIZE OF BUSINESS IN YOUR RESPONSE. STANDARD INDUSTRIAL CODE CLASSIFICATION 3441, SIZE STANDARD 500 EMPLOYEES, APPLIES. The Government requires the purchase of 20' cargo-worthy ISO containers as described below. Subject containers must be delivered as specified in the description provided. If the RDD provided below cannot be met, please provide your earliest availability for delivery of any units that are offered in response to this request for quotes. Please provide unit price, drayage and all other related costs below as applicable. All containers purchased by the Government must have not less than (NLT) one set of fork lift pockets. Container(s) offered to the Government must be in cargo worthy/sea worthy condition. Container(s) must have current CSC inspection and be wind and water tight. Cargo/sea worthy condition inspection incorporates the following: 1. ISO -- No alteration of K-1,K-2, dimensions. 2. WELDS -- No cracked welds on the welds of prime structural components. 3. PANELS -- Dents, bonds and bows up to 50mm into the cube. 4. CORNER POSTS -- Dents to 25mm. 5. TOP SEARAILS -- Dents to 25mm. 6. HEADERS -- Front 25mm, Rear 35mm. 7. BOTTOM RAILS -- Dents up to 50mm (no limit on flanges). Flange comes up to webs, except on bottom side rails. 8. FLP SIDES, CROSSMEMBERS TUNNELS RAILS AND BOLSTERS -- Debris up to 75mm (no limit on flanges) horizontal cuts in webs to 400mm. Flange cuts up to welds. 9. DOORS -- Operable, light & watertight and sealable. 10. FLOOR GOUGES -- Up to 15mm deep and 150mm wide, 5mm deep over 150mm wide, uneven adjacent boards/threshold plate up to 5mm. 11. FLOOR SEPARATION -- Up to 10mm at fastener. 12. RAIN GUTTERS & J BARS -- No interfering with the door. 13. VENTS -- Functioning and watertight or closed off. 14. MARKINGS -- All serial numbers and IS required markings must be legible. TIR and CSC plates must be present. 15. GENERAL -- No missing door hardware. No holes into the cube. No cuts except as noted above. No corrosion that will not pass a hammer test. No hazardous cargo residues or foul odors. The government will require inspection at depot of origin before shipment. Containers are to be delivered FOB Destination. 98-085 36x20' ISO Dry Containers delivered to: (36 units) Westinghouse Engineering Products Division 5301 Sierra Vista Carlsbad, NM 88220 POC: Susan Rivera (505) 234-5617 ALT POC: JOE SCHORK @ (703) 351-7918 Required Delivery Date: 8 July 1998 Price Proposal: Qty Unit Price Extended Price CLIN 0001 ___ EA $__ __ __ __ $__ __ __ ___ 20' ISO Container(s) CLIN 0002 ___ EA $__ __ __ __ $__ __ __ &llmdash;__ Delivery Depot of origin of units offered under this proposal. Name:__ __ __ __ __ ___ Street:__ __ __ __ __ ___ City/State/Zip:__ __ __ __ ___ All responsible sources may submit an offer for consideration by the government via e-mail(wileys@baileys-emh5.army.mil) or FAX (703) 681-9112 by 4:30 PM Eastern Time, 6 May 1998. The anticipated award date is 15 May 1998. Note: The successful offeror is required to provide release numbers for all containers as well as unit numbers so that inspections can be ordered expeditionsly. The trucker must notify the receiving POC 24 hours before delivery of the units. In addition, the contractor must notify Joe Schork, SeaLand Logistics (703) 351-7918of the container numbers to be delivered BEFORE the containers move from the depot of origin. (0122)

Loren Data Corp. http://www.ld.com (SYN# 0388 19980506\81-0001.SOL)